Ian Knot = Ian's Fast Shoelace Knot
order to tie your shoelaces with an "Ian Knot", the World's Fastest Shoelace Knot:
Make a loop with both ends and simultaneously pull them through each other
to form an almost instant knot. Don't confuse this with the very similar
Two Loop Shoelace Knot - the
technique is quite different and much
faster. It's a truly revolutionary way to tie your shoelaces!|
Please don't be put off by these detailed instructions - even the Standard Shoelace Knot looks tricky when illustrated! Give it a try; you'll find it's easier than it looks.
This page gives detailed step-by-step information on the "Ian Knot". If you'd prefer a video presentation, Click Here.
|These diagrams are all drawn as though looking down at your own shoes while tying, and are color-coded to make it easier to follow where the lace runs. The lace end that starts on the left side is Blue and the end that starts on the right side is Yellow. For color-blind visitors, Blue=Dark=Left, Yellow=Light=Right.|
Tie a Left-over-Right Starting Knot as shown, then hold the laces as pictured. The right (blue) lace is held between the right thumb and forefinger whilst the left (yellow) lace is held around the left thumb and forefinger, using the other fingers of the left hand to hold the lace taut.
This move creates two loops, one with the loose end behind, the other with the loose end in front. Use the middle finger of the right hand to push the loose end of the right lace behind, whilst the left hand simply rotates forwards to swing its loop across to the right.
This next move crosses the two loops over each other. Use the left thumb to push its loose end over to the right, whilst the right middle finger continues to push its loose end all the way between the left thumb and forefinger to end up inside the left loop.
Note that the diagram at left shows somewhat exaggerated crossed loops. They are really more "alongside" each other, which is difficult to illustrate.
This tricky move requires each hand to use the two fingers inside its own loop to grab the loose end of the other hand's loop. Use the left thumb and forefinger to grab the loose right end, then the right thumb and middle finger can grab the loose left end.
This move sees each hand releasing its own loop and pulling the loose end of the opposite loop through its own. Take care not to pull the ends all the way through, as this will form a "knot" instead of a "bow". In fact, this is a quick way to tie a starting knot (though the finger movements must be reversed left to right or else it forms a Granny Knot).
This final step simply completes the knot by pulling the loops tight. With practice, you can now tie your laces in about one third of the time of a conventional knot!
|If tied correctly, your finished knot should look like this whether you tied this "Ian Knot", the World's Fastest Shoelace Knot or the Standard Shoelace Knot or the Two Loop Shoelace Knot.|
|NOTE: If your finished knot comes out crooked, it's probably because you tied your Starting Knot the opposite way. This will result in an un-balanced "Granny Knot", which both sits crooked and comes undone more easily. See the Slipping Shoelace Knots page for more information.|
This shoelace tying information has been provide by Ian Fieggen.